Common failures of glass washing machines-troubleshooting methods

If you want to ask what is the most important thing in glass equipment, there is no doubt that the glass washing machine is definitely on the top.Glass washing is an important procedure when processing glass. It is inevitable that some equipment failures will occur in the daily cleaning work, then What are the common glitches of glass washing machines, and what should I do if I encounter these glitches? The following editor will share some of the more common glitches of glass washing machines.

Common faults and solutions of glass washing machine

1. Drive shaft

The drive shaft may experience unstable speed, sometimes faster and sometimes slower, what should I do if this happens?

Solution: This situation is generally caused by the speed control instrument (speedometer) or the loose chain, so it can be solved perfectly by adjusting the chain tightness or replacing the speedometer.

2. Glass shift

In daily glass processing and cleaning operations, what should I do if glass deviation or internal deflection occurs repeatedly?

Solution: This situation is actually very common. The reason is that the two ends of the pressure roller of the equipment are not uniformly stressed and thus offset or internal deflection. We only need to adjust the balance of the pressure roller.

3. Abnormal brush

I believe that many friends have encountered it. Our glass washing machine suddenly has frequent beating brushes during work and makes strange noises from time to time. What should I do in this situation?

Solution: In this case, check the equipment chain as soon as possible. If there is no accident, the core reason is that the chain is loose. Of course, the bearing damage is not ruled out, and the right medicine can be prescribed.

4. Broken glass

What should I do if the glass breaks during normal processing without abnormal operation?

Solution: The factors that cause the glass to break can basically be locked into two points, 1-the brush bearing is damaged, and 2-the pressure roller is not pressed. So the corresponding treatment can be made according to the actual situation.

5. Electrical appliances

During the glass washing operation, the electrical appliances suddenly stopped, causing the washing operation to stop. What should I do if this happens?

Solution: In general, if there is an electrical "strike" without illegal operation, it is usually due to lack of phase in the circuit or damage to the main switch. At this time, we can ask professionals to check the circuit step by step and replace the switch.

6. Water point

During the cleaning operation, there are water spots on the glass. What is the situation?

Solution: If there are water spots on the glass during normal cleaning operations, please check whether the water baffle is damaged in time. If it is not damaged, it means that the suction roller has not been completely softened.

7. Don't hurry glass cleaning

After the cleaning operation is completed, the glass is still not clean or the cleaning is not up to standard, how to solve it?

Solution: If the glass is not clean, we can basically judge that the problem is between the spray pipe or the brush, or the spray pipe is broken (blocked), or the brush spacing is inappropriate, appropriate Just adjust.

 

The above are the 7 common small faults and solutions of glass washing machines summarized by the editor for everyone. I hope to help you. When we use glass washing machines for daily operations, we also need to have a certain understanding and understanding of them. , Only by solving the daily minor faults of some equipment can the cleaning work proceed smoothly.