Glass drilling machine application scenarios-detailed glass drilling process

With more and more glass products, glass crafts, and more and more use of glass edging machines, let me introduce to you the process of safe operation of glass linear edging machines. I hope to be helpful.

With people's love for glass products and the pursuit of glass crafts, the processing requirements for glass have also increased.Simple processing can no longer meet the market demand, and glass processing equipment uses more and more patterns.

Glass drilling machine is one of the commonly used equipment. The following editor will introduce the application scenarios and drilling machine structure of glass drilling machine. I hope it will be helpful to everyone.

Glass drilling machine application scenarios

Glass drilling machine is a professional equipment for drilling various types of glass on the market, so its application scenarios and facing enterprises are also very extensive.

For example, door and window glass, liquid crystal glass, coated glass, insulating glass, tempered glass, electronic digital glass and other industries can be adapted.

According to big data surveys, in the future, people's dependence on glass is much higher than 95% of other products, so the development and demand of the glass market is endless, and the market for glass punching machines will also increase. 

Glass drilling machine drilling process

The glass drilling machine can drill different types of glass, and the general drilling process is like this.

1.First put the glass to be processed horizontally on the operating table.

2.Mark the position where the glass needs to be drilled with a pen or other conspicuous object prepared in advance.

3.When drilling glass, one side of the hole must be drilled first. The electric drill cannot be perpendicular to the drill, and an oblique knife is required.

5. During the operation, it is necessary to continuously water the drill bit and the glass to ensure that the glass will not burst due to excessive friction and heat up.

6.When the glass drilling is about to end, it is necessary to control the feed speed.If the tool speed is too fast, the edge of the hole will crack.

7. Keep the drill bit perpendicular to the glass surface, apply pressure slowly and evenly,

8. After drilling, clean up the debris.

The current glass drilling machine drilling technology is very mature, it is easy to drill out of the glass, as long as the correct operation, there will be basically no accidents, I hope the above article will help you.